Operation of the ** Full-automatic Hydraulic Press is carried
out mostly on the slight-touching keyboard. Parameters can
be set and modified through SIEMENS-OP37 (SIEMENS, Germany),
automatic operation and setting and modifying of various parameters.
Warning graphics automatically appears, insuring operation
and maintenance personnel know the reason of the malfunction
immediately, thus reducing maintenance time.
1.3 The major components of the electric system of ** Full-automatic
Hydraulic Press adopt products from well-known companies at
home and abroad, such as SCHNEIDER, SIEMENS, MITSUBISHI, LISHILE,
OMRON, TUCK, Weidmüller, etc. All these products guarantee
reliability during the system’s life span.
1.4 The instruction manual is applicable to all ** Press series.
The display screen should be kept free of scratches (untrimmed
nails, screwdrivers, etc.), and kept clean at all times.
replacing the modules, you need to reset “Unfilling Lowest”
parameter, and proximity switch of crossbeam lower limit.
5.5 In case
of problems in the electric system, the operation personnel
shall ask help from electric maintenance staff.
mechanical maintenance, the state select switch SA2 of the
hydraulic press should be turned to “SETUP” and guarded by
designated person to prevent misoperation.
main power supply (Observe “operation panel” display and listen
to the warning sound. If there is no display and no warning,
there may be a control breaker tripping. Disposal way: Open
the control cabinet and close the breaker).
environment for the electric-control equipment:
1) Install the equipment below 1000 meters above sea level;
2) Ambient Temperature: Max. +40℃, Min. -20℃;
3) Relative Humidity: not to exceed 95% (indoor temperature
4) No conductive dust and corrosive gas which may destroy
metal and insulation;
5) In a position with no possibility of explosion;
6) Without shaking. Vertical gradient must not exceed 5℃.